[Histonet] Metal molds

[Rene J Buesa]

Yes, after each embedding session.
It is very simple: you just place your molds in the tissue processor in the cleaning cycle and they will come out clean and sparkling.
René J.


________________________________
From: "O'Donnell, Bill" <billodonnell <@t> catholichealth.net>
To: histonet <@t> lists.utsouthwestern.edu 
Sent: Monday, October 8, 2012 4:31 PM
Subject: [Histonet] Metal molds


OK folks, I know I should be smarter than this and I haven't seen
discussion on it lately.... 

Are people cleaning their metal embedding molds after evey embedding
session?

If not, how often do you clean them? 

Do you clean them at all?

If you clean them, how do you do it? 

Thanks

Bill
William (Bill) O'Donnell, HT (ASCP) QIHC 
Senior Histologist
Good Samaritan Hospital
10 East 31st Street
Kearney, NE 68847 

SERENITY is not freedom from the storm, but peace amid the storm.

Cultivate it in PRAYER!




This electronic mail and any attached documents are intended solely for the named addressee(s) and contain confidential information. If you are not an addressee, or responsible for delivering this email to an addressee, you have received this email in error and are notified that reading, copying, or disclosing this email is prohibited. If you received this email in error, immediately reply to the sender and delete the message completely from your computer system.

_______________________________________________
Histonet mailing list
Histonet <@t> lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet