[Histonet] Ribboning Problem Figgered Out!

[Robyn Vazquez]

Sara,
If it is on the knife holder, take your dremel and lightly sand or buff
the nicks out...hope it works before you have to buy a new one...
 
Robyn
OHSU

>>> "Breeden, Sara" <sbreeden <@t> nmda.nmsu.edu> 7/27/2007 11:17 AM >>>

First of all, thank you to all who offered their input on my ribboning
problem.  The advice and counsel was very much appreciated and I
looked
into every solution - so my warm fuzzy thanks!



I did finally figure out what was going on.  Despite the high mileage
vehicle and the moon phases, as I was disassembling it for its usual
Friday Cleaning and Putting Away for the Weekend, I discovered that I
had somehow earlier this week bumped the KNIFE HOLDER against the
chuck,
giving me a tiny indention at each side of that part in the center of
the knife holder that... well, I'm sure it has a name but I don't know
what it is.  I could not see these dents until I took off that little
unnamed part to clean it and there they were!  I always have a new
knife
holder squirreled away, so I am positive that will solve the problems
I
was anticipating on Monday!  My only unpleasant anticipation for
Monday
is telling The Boss I need a new knife holder... gulp!  Wish I could
blame this on another tech, but I am IT!  Rats and mice!  Too bad
there's not some entrepreneur out there that can machine out those
little denty things, thereby saving about $650 for a new one!



By the way, JTT recommended an alcoholic tincture applied to the
technician to solve the problem.... Darn! I'm out of it!



Sally Breeden, HT(ASCP)

NM Dept. of Agriculture

Veterinary Diagnostic Services

PO Box 4700

Albuquerque, NM  87106

505-841-2576



_______________________________________________
Histonet mailing list
Histonet <@t> lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet