[Histonet] RE: Metal molds
Goins, Tresa
TGoins <@t> mt.gov
Tue Oct 9 10:49:13 CDT 2012
We haven't cleaned our molds for five years - if the blocks are cold enough after embedding, there is no problem removing the block.
-----Original Message-----
From: histonet-bounces <@t> lists.utsouthwestern.edu [mailto:histonet-bounces <@t> lists.utsouthwestern.edu] On Behalf Of O'Donnell, Bill
Sent: Monday, October 08, 2012 2:32 PM
To: histonet <@t> lists.utsouthwestern.edu
Subject: [Histonet] Metal molds
OK folks, I know I should be smarter than this and I haven't seen discussion on it lately....
Are people cleaning their metal embedding molds after evey embedding session?
If not, how often do you clean them?
Do you clean them at all?
If you clean them, how do you do it?
Thanks
Bill
William (Bill) O'Donnell, HT (ASCP) QIHC Senior Histologist Good Samaritan Hospital
10 East 31st Street
Kearney, NE 68847
SERENITY is not freedom from the storm, but peace amid the storm.
Cultivate it in PRAYER!
This electronic mail and any attached documents are intended solely for the named addressee(s) and contain confidential information. If you are not an addressee, or responsible for delivering this email to an addressee, you have received this email in error and are notified that reading, copying, or disclosing this email is prohibited. If you received this email in error, immediately reply to the sender and delete the message completely from your computer system.
_______________________________________________
Histonet mailing list
Histonet <@t> lists.utsouthwestern.edu
http://lists.utsouthwestern.edu/mailman/listinfo/histonet
More information about the Histonet
mailing list